Small Household Appliance Thermostat DS-M-T03001 from Yusen
Published Time:
2026-11-05
The Small household appliance thermostat DS-M-T03001 from Yusen Electrical is a mechanical temperature control for electric heating appliances. It is rated CUL 120 V at 13.75 A, has an operating temperature range of minus 50 to 250 degrees Celsius, and is listed with a tolerance of plus or minus 5 percent. The certification number shown on the product page is CUL E350561.
How the Thermostat Works
A small appliance thermostat uses a temperature-sensing element to open and close a set of contacts. When the appliance reaches the set temperature, the contacts open and the heating element stops drawing current. When the temperature falls, the contacts close again and the element heats up. The user sets the point with a simple rotation, and the feedback at the knob makes the adjustment easy to follow.
The DS-M-T03001 is a mechanical type, so it does not need a digital controller or a separate sensor board. That simplicity is useful in an electric iron, a grill or a deep fryer, where the control has to survive heat, steam and repeated use. The product page lists a relatively simple structural design and easy maintenance and replacement as advantages, which matters for a repair or a replacement part.
Electrical and Thermal Ratings
The CUL rating is 120 V at 13.75 A. The endurance test is listed at 100,000 cycles, and the operating range covers minus 50 to 250 degrees Celsius. The tolerance is plus or minus 5 percent. These figures should be checked against the appliance load and the actual temperature profile, because a thermostat that is correct at one set point may behave differently at the top of its range.
The 100,000-cycle figure is a useful guide to service life, but the real life depends on the load, the switching frequency and the environment. A heating element with a high inrush current, a poorly ventilated enclosure or a corrosive atmosphere can shorten the contact life. For a replacement part, matching the original rating and the mounting arrangement is more important than choosing a higher current rating alone.
Typical Applications
The product page lists electric irons, electrical grills, electric ovens, heaters, deep fryers, sandwich makers and other electrical appliances. That range reflects the common use of a capillary or mechanical thermostat in small heating products: the control is close to the heat source, the set point is adjusted by the user, and the cost has to stay in proportion to the appliance.

For an electric iron, the thermostat has to respond quickly and hold a stable soleplate temperature. For a deep fryer, the oil temperature and the safety cut-out matter. For an oven or a grill, the thermostat works with a larger thermal mass and a longer cycle. The same model family can cover these cases when the rating, the probe length and the mounting are matched to the appliance.
Selection and Replacement Notes
When selecting a replacement thermostat, start with the appliance rating and the original part number. Check the voltage, the current, the temperature range and the tolerance, then confirm the shaft or knob type, the mounting holes and the probe length. A thermostat that fits electrically but not mechanically can be difficult or unsafe to install, even if the temperature range looks correct.
It also helps to check the certification mark and the number on the original part. The CUL number on this model is E350561, which gives the buyer a reference for the certification file. For an export appliance, the destination market may require a different mark or an additional approval, so the compliance route should be confirmed before the production order.
Yusen Electrical lists small household appliance thermostats, industrial electric irons and server rack thermostats in its product range. The contact on the product page is sales01@adjthermostat.com. For a quotation, send the appliance type, the voltage and current, the temperature range, the probe or shaft details and the order quantity.
A sample can be checked in the actual appliance before a bulk order. That is the most reliable way to confirm the set point, the differential and the fit. The Yusen team can then confirm the model, the packing and the lead time, and the buyer can release the order against an approved sample rather than a catalogue description alone.
Related Blog